066600240 15337355OK1243756832187 ENDURO881716 Installation of the Computer on Your BikeThe computer is combined with the following The BracketSecure the cord on the fork with the nylon ties 7 and lead to the handle bar along the outercable of the bicycle by means of the spiral tube the rubber pad 6 on the bracket 1 and secure the bracket on the handle bar with thescrew.ĥ Slide the computer into the bracket 1 until you hear the click contact points are automatically closed. When you want to start the odometer from zero,push the START/STOP ButtonMODE ButtonSTART/STOPB uttonInput the current reading of two thedecimal need to know the tirecircumference (L cm) sizeTire size is usually shownon the sidewall of tires. Don t use thinner, benzene or alcohol to wipe the surface of thecomputer.Ģ They may damage the surface of Set-up (For 1st use or after replacing the battery)All ClearPush three buttons (MODE, START/STOP and SET) at the same time.* Do this procedure without fail forstable measurement when you usethis system for the first time and everytime the battery is the odom-eter from the current odometer reading(the odometer starts from the reading youinputted)SETMODEMODEST/STOPST/STOPSet The Tire CircumferenceSet the tire circumference in You can easily set it by referring to the chart is completed by pushing the SET 300 cmDecreasethe numberMin.ģ 100 cmPreparation Complete. Never at-tempt to disassemble the computer head. Avoid unnecessary prolonged exposure to the sun. Dispose of batter-ies according to local regulations. Keep batteries out of reach of small children. Periodically check to insure they aremounted securely and the screws are not loosen. Be sure to securely mount the magnet, the sensor, and thebracket on your bicycle. 1 ImportantNoteWarning Pay attention to the road or trail! Do not be distracted by thecomputer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |